车载激光雷达对北京地区边界层污染监测研究

介绍了自行研制的车载差分激光雷达AML-2探测原理及技术参数,于2006-08、2006-09在不同天气因素条件下对北京西南郊榆垡地区大气边界层污染物O3、NO2、SO2进行了实时监测,对比分析了3种污染物浓度垂直分布及日变化特征.结果表明,无外来污染输送时,3种污染物在阴雨天气总体浓度较小,O3和NO2浓度随高度升高而减小,SO2浓度垂直分布少见此特征,但在近地面0.6 km左右有较强SO2污染层.南部气流输送对北京地区大气环境影响明显,2006-08-23～2006-08-25这次强污染气流输送高度约1～1.5 km,3种污染物浓度垂直分布及日变化特征受到干扰,北京榆垡地区边界层O3、NO2、SO2总体浓度明显上升.     

考虑非线性吸附时溶质在有限厚度粘土中的一维扩散解

在采用非线性分段式吸附等温模式的基础上,建立了溶质在粘土中的一维扩散模型,在考虑有限厚度边界及土中溶质背景浓度的条件下得到了相应的解.模型引入了移动边界以说明当溶质在粘土孔隙水中的浓度达到某一较高值后,阻滞因子将发生显著变化.算例分析表明,该模型和考虑经典非线性吸附等温线得到的结果相差不大,这进一步说明了该模型的合理性.考虑非线性吸附效应对溶质迁移有重要影响.在较高溶质浓度下采用线性吸附等温模式会得到偏不安全的结果.该解相对较简单,并可用于验证各种数值模型、拟合试验数据等.     

极地冻土低温力学特性及井眼坍塌风险分析*

为解决极地冻土区油气资源储量极大但其力学特性和钻井井壁失稳机理尚不清晰的问题,对冻土岩样开展低温三轴力学特性实验,并基于此开展钻井井壁坍塌失稳相关数值模拟分析。结果表明:冻土的极限强度会随温度的降低和围压的增大而逐渐提高;冻土弹性模量尽管会随温度的降低而增加,但受围压影响较小,而泊松比基本不受温度及围压的影响;冻土内聚力会随实验温度的降低得到较大幅度提升,但不同实验温度范围内温度对冻土内聚力的影响程度存在差异,实验温度高于-12.5 ℃时温度对冻土内聚力的影响较强;极地冻土储层钻井过程近井地带冰的分解会随钻井作业的进行而逐渐变慢,冰的最终分解前缘位置为0.079 6 m,井眼扩大率达到63.51%。研究结果可为极地冻土层油气资源钻井作业设计提供参考与指导。     

A numerical study of summer ozone concentration over the Kanto area of Japan using the MM5/CMAQ model

We assessed the ability of the MM5/CMAQ model to predict ozone (O3) air quality over the Kanto area and to investigate the factors that a ect simulation of O3. We find that the coupled MM5/CMAQ model is a useful tool for the analysis of urban environmental problems. The simulation results were compared with observational data and were found to accurately replicate most of the important observed characteristics. The initial and boundary conditions were found to have a significant e ect on simulated O3 concentrations. The results show that on hot and dry days with high O3 concentration, the CMAQ model provides a poor simulation of O3 maxima when using initial and boundary conditions derived from the CMAQ default data. The simulation of peak O3 concentrations is improved with the JCAP initial and boundary conditions. On mild days, the default CMAQ initial and boundary conditions provide a more realistic simulation. Meteorological conditions also have a strong impact on the simulated distribution and accumulation of O3 concentrations in this area. Low O3 concentrations are simulated during mild weather conditions, and high concentrations are predicted during hot and dry weather. By investigating the e ects of di erent meteorological conditions on each model process, we find that advection and di usion di er the most between the two meteorological regimes. Thus, di erences in the winds that govern the transport of O3 and its precursors are likely the most important meteorological drivers of ozone concentration over the central Kanto area.     

大连金州地区海陆风及热内边界层研究

根据大连金州2009年常规气象站资料分析大连金州地区海陆风变化特征,并用MM5V3模式模拟典型日的海陆风风场变化和热内边界层位温场结构变化,结果表明:海风和陆风出现的频率有明显的季节性变化。冬季陆风较多,春夏海风较多,春季、冬季易形成海陆风;海风起止时间夏季长冬季短,陆风起止时间秋冬季较夏季长;典型海陆风日中,海风造成陆地湿度变大,海风风速大于陆风风速;通过海风的数值模拟,海风由生成到成熟海岸吹向内陆其厚度可增厚到1 000 m以上,伸向内陆距离可到18.9 km;热内边界层向内陆呈舌状分布,海岸边界层高度在700 m之间,抛物面高度随着向内陆延伸的距离增加而升高。热内边界层最高达1 000 m。     

静电除尘器的粉尘非稳态收集过程

为了全面揭示电除尘器粉尘非稳态收集过程,建立完整的非稳态静电收尘理论,根据静电学基本原理,研究了极板粉尘层电荷导人、积累、释放的过程,推导出随粉尘层厚度增长而改变的动态收尘电场强度计算公式,进而得到荷电粒子动态驱进速度公式,最终形成静电除尘非稳态收集理论.研究结果表明,在静电收尘过程中,粒子驱进速度与粉尘比电阻、工作电压、粉尘层厚度等多种因素有关;随粉尘比电阻的升高,收尘效率下降,当供电电压为最佳工作电压时收尘效率最高.针对不同比电阻粉尘进行了多项实验研究,实验结果与理论研究结果吻合.非稳态静电收尘理论成功地解释了实际静电收尘过程中与传统静电收尘理论相矛盾的地方,为静电除尘器的设计及其运行参数的选取提供了更为科学的理论基础.     

恶臭假单胞菌Pseudomonas putida 5-x细胞壁膜系统的Cu2+吸附性能

对1株从电镀废水中分离出的革兰氏阴性菌恶臭假单胞菌P.putida 5-x的细胞表面组分对Cu²⁺的吸附性能进行了分析研究.结果表明,分离的P.putida 5-x细胞壁膜的Cu²⁺吸附容量是完整细胞的5倍之多.细胞表面组分如肽聚糖层、细胞外膜和细胞内膜在P.putida 5-x细胞壁膜的Cu²⁺吸附过程中都发挥了作用.肽聚糖层、细胞外膜和内膜在P.putida 5-x细胞壁膜中的含量依次为细胞内膜>外膜>肽聚糖层,而它们的Cu²⁺吸附容量的大小依次为肽聚糖层>外膜>内膜.在P.putida 5-x细胞壁膜对Cu²⁺的吸附过程中,肽聚糖层贡献了不到15%的吸附容量,而细胞外膜和内膜分别贡献了30%～35%和25%～30%.P.putida 5-x细胞外膜中的磷脂含量明显比其它报道的革兰氏阴性细菌的细胞外膜高,这可能是P.putida 5-x细胞外膜具有较高Cu²⁺吸附容量的主要原因,并由此导致P.putida 5-x细胞壁膜的高Cu2+吸附容量.     

不同好氧预处理方式对餐厨垃圾产甲烷的影响

为了研究不同好氧预处理方式对餐厨垃圾厌氧消化产甲烷的影响,通过建立3个模拟厌氧生物反应器,研究了传统厌氧生物反应器C1、上层好氧预处理-厌氧生物反应器C2和底部好氧预处理-厌氧生物反应器C3 3种不同操作条件下的产甲烷过程.结果表明,挥发性有机酸的累积使C1始终处于产甲烷滞后阶段;而C2、C3的好氧预处理通过加快易水解酸化组分和过量挥发性有机酸的好氧降解,有效缓解了酸性抑制,产甲烷滞后时间明显缩短至10 d内.第32天C2停止上层曝气后,在27 d内甲烷浓度达到了50％以上,同时,产甲烷速率迅速上升,并在第81天可达到峰值773 mL/(kg·d).C3在第11天停止底部曝气后,虽然经过22 d的时间甲烷浓度即上升至50％,但之后产甲烷速率经历回落阶段后再次逐渐上升,在实验结束时仅达到517 mL/(kg·d).上层曝气的好氧预处理方式所需曝气时间相对较长,但其产甲烷启动快,与底部曝气相比,其后期的甲烷化过程更稳定并可达到较高的产甲烷速率.     

Hydraulic fracturing as an interpretive policy problem: lessons on energy controversies in Europe and the U.S.A.

This special issue addresses hydraulic fracturing for shale gas extraction as an interpretive policy problem. Bringing together empirical cases from the U.S.A., the Netherlands, the U.K., Poland, and Germany, we identify three approaches to the interpretation of hydraulic fracturing in the article: understanding its meaning, contextual explanation of the institutionalization of its meaning, and policy design as intervention to alter its meaning. By exploring differences and similarities across these cases, we identified two central tensions in the meaning of shale gas in all cases: (1) economic opportunity or environmental threat and (2) transition toward a more carbon-free energy future or perpetuation of a fossil fuel system. We found that when actors shift the meaning of hydraulic fracturing to consider it predominantly an issue of threat, this explains the dominance of risk governance as an approach to managing the controversy. Alternately, when the meaning of fracking shifts from consideration as an economic opportunity or a bridge fuel to consideration of it as a barrier to an energy transition, this explains the decision to ban fracking. Therefore, a comparative assessment of the papers demonstrates the ways interpretive dimensions of politics can influence the governance of public policy.     

Investigation of titanium liquid/gas diffusion layers in proton exchange membrane electrolyzer cells

In a proton exchange membrane electrolyzer cell (PEMEC), liquid/gas diffusion layer (LGDL) is expected to transport electrons, heat, and reactants/products to and from the catalyst layer with minimum voltage, current, thermal, interfacial, and fluidic losses. In addition, carbon materials, which are typically used in PEM fuel cells (PEMFCs), are unsuitable in PEMECs due to the high ohmic potential and highly oxidative environment of the oxygen electrode. In this study, a set of titanium gas diffusion layers with different thicknesses and porosities are designed and examined coupled with the development of a robust titanium bipolar plate. It has been found that the performance of electrolyzer improves along with a decrease in thickness or porosity of the anode LGDL of titanium woven meshes. The ohmic resistance of anode LGDL and contact resistance between anode LGDL and the anode catalyst play dominant roles in electrolyzer performance, and better performance can be obtained by reducing ohmic resistance. Thin titanium LGDLs with straight-through pores and optimal pore morphologies are recommended for the future developments of low-cost LGDLs with minimum ohmic/transport losses.